About the Kenwood Excelon XR-W1002
High-performance bass
High-performance bass
Kenwood puts their most advanced technology into the Excelon subwoofers, so you can enjoy reliable high-performance bass in your ride. The oversized XR-W1002 10" sub is designed to move more air than a standard sub, which means more sound in your vehicle. It comes equipped with an oversized polypropylene cone attached to a heavy-duty rubber surround that allows for extra excursion, so it'll faithfully reproduce those low notes. The XR-W1002 is rated to handle up to 300 watts RMS so you know it's ready to rock.
Keeping it cool
A dual ventilation system forces heated air out of the motor structure through the back and the sides of the housing, so the sub stays cooler during extended play. This ventilation system also allows this sub to operate in a shallow enclosure, good news if you're building a box to go in a tight spot. Install this Kenwood in a suitable box, hook up a nice amp, and you're ready to rumble.
Subwoofer Wiring Diagrams
To see sample wiring diagrams for all common subwoofer/amplifier combinations, check out this informative article.
Product highlights:
- 10" 2-ohm component subwoofer
- oversized polypropylene cone with rubber surround
- power handling: 300 watts RMS (1300 watts peak)
- frequency response: 31-300 Hz
- sensitivity: 80 dB
- top mount depth: 4-13/16"
- grille not included
- warranty: 2 years
- MFR # XR-W1002
What's in the box:
Kenwood Excelon XR-W1002 owner's manual
- One 10" Subwoofer
- Eight 1-3/8" Screws
- Adhesive backed foam gasket
- Cardboard template
- Instruction manual (English/ French/ Spanish/ Portuguese)
- Warranty information
- Specs on box lid
Customer reviews for Kenwood Excelon XR-W1002
Loading...
Loading reviews...
Average review:
5.0 out of 5 starsCustomer photos
This review was collected as part of a promotion
Pros:
Cons:
More details on the Kenwood Excelon XR-W1002
Features & specs
Features and Specs | ||
---|---|---|
Size | 10 -inch | |
Impedance (Ohms) | 2 | |
Cone Material | Polypropylene | |
Surround Material | Rubber | |
Port diameter (inches) | N/A | |
Port length (inches) | N/A | |
Free-Air | No | |
Dual Voice Coil | No | |
Sensitivity |
80 dB at 1 watt | |
Frequency Response | 31 - 300 Hz | |
Max RMS Power Handling | 300 | |
Peak Power Handling (Watts) | 1300 | |
Top Mount Depth (inches) | 4 13/16 | |
Bottom Mount Depth (inches) | N/A | |
Cutout Diameter or Length (inches) | 9 1/16 | |
Frame Width | 10.82 | |
Frame Length | 10.82 | |
Vas (liters) | 63.8 | |
Fs (Hz) | 24.1 | |
Qts | 0.394 | |
Xmax (millimeters) | 11.6 | |
Parts Warranty | 2 Years | |
Labor Warranty | 2 Years | |
Box Requirements | ||
Ideal Sealed Box Volume (cubic feet) | 0.55 | |
Minimum Sealed Box Volume (cubic feet) | 0.45 | |
Maximum Sealed Box Volume (cubic feet) | 0.76 | |
Ideal Ported Box Volume (cubic feet) | 0.9 | |
Minimum Ported Box Volume (cubic feet) | 0.7 | |
Maximum Ported Box Volume (cubic feet) | 1.24 |
Product Research
Features
Sealed Enclosure Applications: Kenwood recommends sealed enclosure volumes from 0.45 ft³ to 0.75 ft³, with an optimum volume of 0.55 ft³. Sealed enclosures provide the most control over a woofer, will handle a lot of power, and provide accurate sonic reproduction, making them suitable for all types of music.
Ported Enclosure Applications: Kenwood recommends ported enclosure volumes from 0.7 ft³ to 1.2 ft³. The optimum volume is 0.9 ft³ with a 10-3/4" wide x 1-1/8" tall x 25-1/2" long slot port. Ported (or vented) enclosures typically provide better overall efficiency than sealed, so they are suitable for use with smaller amplifiers, giving you more bass output from less power. However, this efficiency comes at the expense of very low frequency output.
Spring Terminals: The spring post terminals will accept pin connectors, single banana plugs, or bare wire up to 8 gauge.
Additional Measurements:
- Frame: the speaker frame doesn't have a uniform diameter; at the widest points the diameter is 12.585", at the narrow points it's 10.820"
- Woofer Displacement: 0.062 ft³ (1.8 liters)
Loading...
Loading accessories...
Customer Q&A
Loading...
Loading articles...
They subs look awesome getting ready to buy a couple of these tens I will post again and let you know how they sound soon and by the way I will be using a touchscreen Kenwood receiver with six by nines Kenwood 4 door speakers
Charlie from Lowry, MO