About the Scosche C4FDK5 Wiring Interface
The Scosche C4FDK5 wiring interface allows you to integrate a high-powered aftermarket receiver into select 1988-up Ford, Lincoln, Mercury, Mazda, and Nissan vehicles with premium factory systems. The package includes the OEA-4 adapter and a Ford-specific harness. The OEA-4 unit has output-level gain controls for each of its four channels which can be adjusted to properly match the new receiver to the factory amplifier.
Note: If you haven't already, please enter your vehicle information or call a Sales Advisor at 1-888-955-6000 to find out if this adapter is compatible with your vehicle.Details:
- 4 speaker-level inputs
- output level adjustments for all four channels
- works best with high-powered aftermarket receivers
- dimensions: 3-15/16"W x 15/16"H x 2-1/16"D
- 1-year warranty
What's in the box:
- OEA-4 OEM Amp interface (with 8-wire input with bare wires/8-wire output with black square connector)
- Vehicle power wiring adapter (gray rectangular connector w/ 6 wires)
- Flat-blade screwdriver (attached to interface module)
- 13 Crimp caps
- Instruction sheet
More details on the Scosche C4FDK5 Wiring Interface
Compatibility: The OEA-4 (model C4FDK5B) is a non-electronic interface that allows an aftermarket high-power stereo to integrate into select 1988-2000 Ford, Lincoln, Mercury, Mazda and Nissan vehicles with premium factory systems. Please check the Crutchfield Vehicle Selector for compatibility for your vehicle.
Adjustment Gain Controls: Four rotary gain controls (front left, front right, rear left, rear right) are located recessed inside the adapter chassis. There is a small flat-blade screwdriver attached to the adapter's case, and its use is recommended. The controls are very fragile and sensitive, and a slight adjustment will change volume dramatically.
Harnesses: The adapter's input wires are approximately 5-1/2" long with bare ends. These splice to the new receiver's speaker output wires. The adapter's output wires are approximately 11" long and terminate into a black square Molex plug. There is an additional gray rectangular Molex plug with 6" wires with bare ends (These 6 wires splice to the new receiver's power/ground wires). The two Molex plug ends are molded to match with factory wiring harnesses. Crimp caps are provided for wire splices.
Q Crutchfield asked: Why did you buy this?