About the Crux SWRHN-62D Wiring Interface
Add a new radio
You'll only be able to retain your steering wheel audio controls with a compatible car stereo made by Alpine, Blaupunkt, Clarion, JVC, Kenwood, Pioneer, or Sony. No other brands are currently compatible.
Add a new radio
Installing a new car stereo can often mean losing your vehicle's steering wheel audio controls. Crux's SWRHN-62D wiring interface solves this problem, allowing you to install a new receiver while retaining the steering wheel controls. The interface also includes an adapter for the powered antenna.
The interface does not support amplified systems, and it doesn't retain factory navigation or your rear seat entertainment system.
- connect a new stereo in select 2003-11 Honda vehicles
- retain your steering wheel audio controls with select car stereos by Alpine, Clarion, JVC, Kenwood, Pioneer, or Sony
- includes adapter for power antenna
- warranty: 1 year
- Our 60-day money-back guarantee
- MFR # SWRHN-62D
What's in the box:
- Radio replacement interface module
- Wiring harness
- Antenna adapter
- SWC harness
- SWC adapter
- Installation Instructions
More details on the Crux SWRHN-62D Wiring Interface
Honda Radio Replacement Interface: The CRUX SWRHN-62D is a radio replacement interface for select 2003-2011 Honda vehicles. It facilitates the integration of an aftermarket radio to enable retention of factory features when replacing a factory installed radio in select Honda vehicles. This interface is also pre-programmed for retention of steering wheel controls.
Note: This Honda radio replacement interface does not support factory amplified systems, RSE (Rear Seat Entertainment), or Factory Navigation.
Compatibility: The CRUX SWRHN-62D is supported by the following 2003-2011 Honda vehicles; with non-amplified and non-navigation factory systems only.
Steering Wheel Control Retention: The CRUX SWRHN-62D also features a steering wheel control output for Pioneer, Sony, Alpine, Clarion, Kenwood, JVC, and Blaupunkt aftermarket head units. The steering wheel control output consists of a right-angle 3.5mm connector and a light blue/yellow wire (use the connection that your aftermarket head unit is fitted with). The SWRHN-62D interface module will work with a variety of aftermarket head units, by setting its dip-switches (see owner's manual for appropriate setting). A third female steering wheel control adapter is provided for converting the 3.5mm plug into individual wires: SWC Key 1 (Red), SWC Key 2 (White), and SWC Ground (bare copper wire).
Q Crutchfield asked: Why did you buy this?
2 questions already asked