About the Crux SWRHN-62L Wiring Interface
Add a new radio
You can retain your steering wheel audio controls with a compatible car stereo made by Alpine, Clarion, JVC, Kenwood, Pioneer, or Sony. No other brands are currently compatible.
Add a new radio
Installing a new car stereo can often mean losing your vehicle's steering wheel audio controls. Crux's wiring interface solves this problem, allowing you to install a new receiver while retaining those controls. The interface also includes an adapter for the powered antenna. The interface does not support amplified systems, and it doesn't retain factory navigation or your rear seat entertainment system.
- connect a new stereo in select 2008-up Honda vehicles
- retain your steering wheel audio controls with select car stereos by Alpine, Clarion, JVC, Kenwood, Pioneer, or Sony
- includes adapter for power antenna
- warranty: 1 year
- Our 60-day money-back guarantee
- MFR # SWRHN-62L
What's in the box:
- Radio replacement interface module
- Wiring harness
- Antenna adapter
- 2 SWC harnesses
- Installation Instructions
More details on the Crux SWRHN-62L Wiring Interface
Honda Radio Replacement Interface: The CRUX SWRHN-62L is a radio replacement interface for select 2008-2013 Honda vehicles. It facilitates the integration of an aftermarket radio to enable retention of factory features when replacing a factory installed radio in select Honda vehicles. This interface is also pre-programmed for retention of steering wheel controls.
Note: This Honda radio replacement interface does not support factory amplified systems, RSE (Rear Seat Entertainment), or Factory Navigation.
Compatibility: The CRUX SWRHN-62L is supported by the following 2008-2013 Honda vehicles; with non-amplified and non-navigation factory systems only.
Note: *This interface does not retain the factory radio display in Honda Accord or Honda Pilot.
Steering Wheel Control Retention: The CRUX SWRHN-62L also features a steering wheel control output for Pioneer, Sony, Alpine, Clarion, Kenwood, JVC, and Blaupunkt aftermarket head units. The steering wheel control output consists of a right-angle 3.5mm connector and a light blue/yellow wire (use the connection that your aftermarket head unit is fitted with). The SWRHN-62L interface module will work with any of the listed aftermarket head units, by setting its three dip-switches (see owner's manual for appropriate setting).
Note: There are two steering wheel control harnesses labeled "Pioneer/Sony" and "Alpine/Clarion/Kenwood/JVC"). You will only plug in one of these harnesses into the interface module, based on the type aftermarket head unit you are installing.
Wiring Harness: The SWRHN-62L includes a wiring harness with a single 24-pin molex connector that plugs into your vehicle's factory radio harness. the SWRHN-62L interface module. On the other end of the harness is a 12-pin connector that plugs into the interface module. The wiring harness also provides bare-wire leads (power/ground, speaker, illumination, antenna, and vss) which will need to be hardwired to your aftermarket head unit's wiring harness. In addition, there is an antenna adapter to allow your aftermarket head unit to connect with the vehicle's factory AM/FM antenna.
|Red||+12 Volt Accessory|
|Yellow||+12 Volt Constant|
|White||Left Front Speaker +|
|White/black||Left Front Speaker -|
|Gray||Right Front Speaker +|
|Gray/black||Right Front Speaker -|
|Green||Left Rear Speaker +|
|Green/black||Left Rear Speaker -|
|Purple||Right Rear Speaker +|
|Purple/black||Right Rear Speaker -|
Q Crutchfield asked: Why did you buy this?