Chat
Contact us
Close contact box
Connect ID #
261 619 23
Connect ID #
261 619 23
All finished with your chat session?

We’ll email you a transcript of this conversation for your records.

All of our representatives are
currently chatting with other customers.

Please enter your name.  
Please enter a valid email address. Why is this required?
Please enter your US phone number.  

For Tech Support, call 1-888-292-2575

Thank you, !
Our conversation will be emailed to
Please enter a question  
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  

Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

Rockford Fosgate P3D2-15

Punch P3 15" subwoofer with dual 2-ohm voice coils

Item # 575P3D215

Item # 575P3D215

In stock
C$479.99 each

About the Rockford Fosgate P3D2-15

Standout performance

Rockford Fosgate showcases their fanatical commitment to sonic excellence in the Punch Series of speakers, amps, and subs. If you like to listen to potent, powerful music — and feel it too — Punch components will give you impressive sound that'll stand out in a crowd.

Exploded view

Designed for deeper, louder bass

Rockford Fosgate designed the P3D2-15 15" subwoofer to stay strong even when the bass gets hot. This Punch P3 sub features a rigid anodized aluminum cone that holds its shape through heavy play, while staying light and responsive. Rockford Fosgate uses a new technique to attach the oversized rubber surround to the cone that increases available cone area up to 25%, so this sub can push more air for even bigger bass.

Heat-sink cone

The aluminum cone acts as a giant heat sink, directing heat away from the copper-clad aluminum voice coils. Special venting keeps the voice coils cool, so you get incredibly consistent bass performance over time. This P3 sub features an extended pole piece and bumped backplate that leaves more room for heavy excursion, so it'll hit deeper lows without "bottoming out."

The dual 2-ohm voice coils allow you to wire the sub for 1-ohm impedance to get maximum power output, or for 4-ohm impedance if you're using multiple subs. The P3D2-15 sub works equally well in a sealed or ported enclosure, so you can choose the kind of bass you want for your system.

Product highlights:

  • 15" subwoofer with dual 2-ohm voice coils
  • anodized aluminum cone with Santoprene surround
  • hybrid StampCast basket provides strength while minimizing weight and resonance
  • Vertical Attach Surround Technique (VAST™) increases cone area
  • power range: 300-600 watts RMS (1200 watts peak power)
  • frequency response: 22-250 Hz
  • sensitivity: 86 dB
  • top-mount depth: 7-5/8"
  • sealed box volume: 1.5-3.0 cubic feet
  • ported box volume: 2.66 cubic feet
  • grille not included
  • warranty: 1 year
  • Our 60-day money-back guarantee
  • MFR # P3D2-15

What's in the box:

  • One 15" Dual 2-ohm voice coil subwoofer
  • Trim ring
  • Twelve 1-1/8" Allen head screws
  • 4mm Allen head bit
  • Installation/Operation manual (English/ French/ Spanish/ German)

Customer reviews

Loading reviews...

Rockford Fosgate P3D2-15 reviews

Average review:

15 reviews

Filter by rating

Customer photos

Sort reviews

Sort by:
Items per page:
View page:

Verified customer (What's this?)
Verified employee purchase (What's this?)

Pros:

Cons:

Crutchfield response

<< >>

More details on the Rockford Fosgate P3D2-15

Pat M.

Product Research

Features
Enclosure Compatibility

Features

Overview: The Rockford Fosgate Punch P3D2-15 is a 15-inch subwoofer with dual 2Ω voice coils. The sub features a hybrid StampCast basket, quick-release compression terminals, anodized aluminum cone, and Santoprene surround. An anodized aluminum voice coil former and spider venting help keep the subwoofer cool.

Dual 2Ω Voice Coils: The dual 2Ω voice coils offer wiring flexibility; when wired in parallel the woofer presents a 1Ω load, when wired in series the woofer presents a 4Ω load.

Compression Terminals: The P3D2-15 features spring post terminals which accommodate speaker wire up to 10 gauge.

CEA-2031 Compliant: Power handling on the P3D2-15 subwoofer conforms to CEA-2031 industry standards. This means the subwoofer has the capacity to handle power under continuous demand, not instantaneous power handling, that over time, can damage voice coils.

FlexFit Basket: The Flex Fit frame utilizes slots (where possible) instead of single screw sized holes; allowing slight adjustment of the speaker when mounted.

Trim Ring: To improve the cosmetic look, a decorative trim ring is included that mounts over the flange of the woofer. When using the cast aluminum trim ring the woofer is first mounted with four screws, then the ring is placed on top of the woofer, aligning the final four holes of the woofer with ring. The other four screws are used for these holes to mount the ring and woofer to the enclosure. Without the trim ring the mounting height of the woofer is just under an inch, with the trim ring it's approximately 1-1/16 inches. The diameter of the trim ring is approximately 16-3/8 inches.

Enclosure Compatibility

Sealed Box: Rockford recommends a sealed enclosure with an optimum internal volume of 1.58 cubic feet (from 1.5 to 3.0 cubic feet is acceptable). Sealed enclosures provide the most control over a woofer, will handle a lot of power, and provide accurate sonic reproduction, making them suitable to all types of music.

Ported Box: Rockford recommends a ported enclosure with an internal volume of 2.66 cubic feet using one 4" diameter x 10" long port; this yields a tuning frequency of 32 Hz. Ported (or vented) enclosures typically provide better overall efficiency than sealed so they are suitable for use with smaller amplifiers, giving you more bass output from less power. However, this efficiency comes at the expense of very low frequency output (below 30 Hz).

Loading accessories...

Customer Q&A

5 questions already asked

Q
Will the punch 1000x 1 ohm amp work better with a single punch P3 15 2 ohm or two punch 15 inch subs?
[ Kelii  Apr 29, 2020 ]
1 answer
A
If you are talking about the P1000X1bd model amp, it can work with one or two of the P3D4-15 DVC 4 ohm subs. I do not recommend this amp for the DVC 2 ohm version of the subwoofer. If you are referring to a different modal amp, I recommend contacting an advisor on 1-800-324-9695 to get a personal recommendation on a setup
[ Paul  May 24, 2020 ]  Staff
Q
Will the punch 1000x 1 ohm amp work better with a single punch P3 15 2 ohm or two punch 15 inch subs?
[ Kelii  Apr 29, 2020 ]
3 answers
A
By far that would be over kill you will not be pleased and wast your money
[ Ryan  May 02, 2020 ]
A
Yes it will. I have a old punch 1000db on a single p3 15 dual 2 ohm sub. Sounds awesome and the amps turned down! They only need around 500 watts rms. So it such do fine either way.
[ ABE  Apr 29, 2020 ]
A
I would bridge my amp and run it to 2 15's. And lose my hearing. Gd luck.
[ Rusty  Apr 29, 2020 ]
Q
I have a Rockford fosgate p3 15 in a custom I guess you can call it a built to specs high output ported enclosure. I came across my oldschool jl audio 250/1 amp was only used for two days and it's been put away in the box for over 10 years now inside my closet will this amp work with that sub?
[ Brian  Aug 05, 2018 ]
1 answer
A
Thanks for your question. For information on selecting the best amp for your subs I would recommend reaching out to an Advisor by phone (1-800-324-9695) or online chat. They will be able to help determine the differences between the amp models and help you make the best choice for your system.
[ Krissy  Aug 10, 2018 ]  Staff
Q
Box volume when running 2 p3 D215 sealed box common air?
[ Brian  Jun 04, 2017 ]
2 answers
A
Sealed
[ Rusty  Apr 29, 2020 ]
A
Rockford recommends a sealed enclosure with an optimum internal volume of 1.58 cubic feet for a single 15" P3D2 subwoofer; when using two you can simply double that number which comes out to 3.16 cubic feet total volume for dual subs. If you would like to discuss further, feel free to contact an Advisor directly by phone (1-800-324-9695) or online chat. Thanks! My Bio: https://www.crutchfield.com/advisors/larry
[ Larry  Jun 07, 2017 ]  Staff
Q
How Do i wire 1 15" sub to an alpine 1000 watt mono amp?
[ rudy  Dec 08, 2013 ]
1 answer
A
If you purchased the product from Crutchfield, feel free to contact our Tech Support team. They can walk you through the settings on the product and see if there may be a fix. Our toll-free Tech Support number is printed on your invoice, and is also available under the "My Orders" tab in the "My Account" section of our website. If you did not purchase the unit from Crutchfield, then you may want to contact the manufacturer. You can also post your question in our forums: http://community.crutchfield.com. Or try our online support center: http://crutchfield.custhelp.com/app/answers/list/kw/.
[ Jeff  Dec 09, 2013 ]  Staff
SHOW MORESHOW LESS

Loading articles...

TOP