About the Posi-Products™ Car Speaker Connectors
Posi-Products connectors help make your electrical connections fast, easy, and reliable with no crimping, soldering, or messy tape. Just strip your stranded wires, insert them in the caps, and then hand tighten the two caps together — the wire ends get locked between opposing cone shapes to create a water-, dirt-, vibration-, and heat-proof housing. You get a strong, low-resistance electrical connection, and you can reuse the connectors, too.
The Mobile Electronics Series Connector Kits come with various assortments of special Posi-Lock® and Posi-Tap™ connectors with gold-plated contacts to integrate your aftermarket equipment into your vehicle's electrical system. Experienced installers have selected the contents of each kit carefully, so you can be sure you'll have all the right connectors necessary to get the job done.
This Speaker Connector Kit comes with 8 Posi-Tap tap connectors so you can hook up aftermarket speakers to your existing speaker wires. Warranty: 30 days.
More details on the Posi-Products™ Car Speaker Connectors
Overview: This Speaker Connector Kit comes with 8 Posi-Tap tap connectors so you can connect aftermarket speakers to your existing speaker wires. Posi-Tap connectors allow you to tap into wires without cutting or stripping them. Each connector has a tapered design and a threaded cap on each end. Just insert wire to be tapped into the large cap (this is the Tap end) and hand tighten into the barrel. The conductor point pierces the tapped wire without compromising its conductive integrity. Insert the stripped wire through the small cap (this is the Accessory end), then tighten. An internal conductor runs the length of the Posi-Tap, giving you a solid electrical connection. The Posi-Tap connectors are vibration proof, fully insulated, and reusable.
- Clear Posi-Tap Connectors: compatible
with 18 gauge wire on the Tap end and 14-20 gauge wire on
the Accessory end
- Length: 1.25"
- Maximum Diameter: 0.385"
- Width of Slot in Large Cap (Tap end): 0.07"
- Diameter of Hole in Small Cap (Accessory end): 0.15"
6 questions already asked