Features

Plus One Woofer Cones: The Plus One woofer cones offer more surface area than other speakers that fit in the same size opening. This is accomplished by using a new basket design and hi-roll surround. The result is greater bass output and an increase in efficiency.

High-Output Design: The high output 2.5Ω voice coil design compensates for the high in-line resistance of small gauge factory wiring and extracts every watt from factory receivers, increasing overall system output and efficiency (relative to 4Ω speakers). The speakers also benefit from increased power when you upgrade the wire and add aftermarket amplifiers, designed to power a 2.5Ω load.

Woofer Mounting Applications: These speakers are marketed as 6-1/2"; the woofers will fit in standard 6-1/2" speaker openings (approximately 5" diameter), but do not use the standard 6-1/2" speaker bolt pattern. In order to install them in standard 6-1/2" speaker openings you must drill new screw holes. If new holes are drilled in the mounting surface of the car, no bracket is needed. If drilling in the car is not an option, the included brackets can be used, which have standard 6-1/2" mounting holes and the Ford non-symmetric four hole pattern. When using the brackets the depth becomes 1.868" and the mounting height becomes 0.755".

Woofer Terminals: The woofers' input terminals are set screws that will accept up to 12 gauge bare wire.

Edge Driven Tweeters: The edge-driven tweeters use textile soft domes. An edge-driven tweeter has better dispersion characteristics and allows for a lower crossover frequency than typical tweeters of the same size, which improves imaging, vocals and musical clarity.

Tweeter Mounting: The I-Mount tweeter mounting system and Starfish mounting brackets give you several different ways to mount the tweeters:

• I-Mount Tweeter Mounting System: The tweeters can be surface or flush mounted with Infinity's innovative I-Mount system:
  • Surface Mount: Surface mounting the tweeters involves screwing the surface-mount cup to the mounting location, then inserting and locking the tweeter into the cup.
  • Flush Mount: Flush mounting is made easy through the use of the threaded flush-mount adapter and plastic locking nut. Once a cutout is made, the flush-mount adapter (with the tweeter installed) is inserted into the hole. The large plastic locking nut is threaded onto the adapter (from behind the mounting surface) to hold the complete assembly securely in place. When flush mounted, the tweeters may be angled for optimum response and imaging.
• Starfish Mounting Brackets: The Starfish mounting brackets allow the tweeters to be installed in factory locations behind the grilles:
  • Surface Mount (behind grille panel): Once the Starfish bracket is trimmed, it is screwed to the mounting surface behind the grille panel. Then, the tweeter is inserted into the bracket and locked into place.
  • Flush Mount (behind grille panel): Once the Starfish bracket is trimmed, it is dropped into the cutout in the mounting surface behind the grille panel. Then, the tweeter is inserted into the bracket and locked into place.
  • Bottom Mount (to grille panel): Once the Starfish bracket is trimmed, it is secured to the underside of the grille panel. The tweeter must be inserted into the bracket and locked into place before the bracket is mounted.

Tweeter Mounting Dimensions:

Crossovers: Each crossover has a tweeter output level switch; choose between flat and +3dB. They have screw terminal inputs and outputs that will accept gauge bare wire or spade connectors up to 0.315" wide.

Crossover Dimensions:

• Diameter: 4-3/8"
• Height: 1-3/8"

3-Way Upgrade: The system crossovers are gap-selectable, to accommodate a midrange upgrade. The optional 20mx midrange (item number 108K20MX, sold separately) includes band pass crossover to upgrade this two-way system to a three-way system with perfect tonal balance.