Customer Reviews

Metra 95-6539 Dash Kit

No comment

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Unit was a little difficult in matching the existing dash clips. Had to modify dash somewhat to get it to fit properly, once done it looks good.

Have questions for
?

Crutchfield response on

Adequate

Nothing fancy and does the job. In this case the finish does a decent job of matching the car interior - but ymmv.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Perfect fit looks great.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Fit perfect. Super easy to install on a 2002 Town and Country

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Seems better that the typical Dodge plastics. Didn't have they same textured sides like original part but looks good. The radio opening required a bit of work to allow better fitment of the stereo but nothing that a rotary tool and sandpaper couldn't fix.

Have questions for
?

Crutchfield response on

Well made , but not a fantastic fit.

It fits well in 2003 grand caravan. However, I needed to modify some things behind the stock stereo to fit the double din. The space for the double din (Pyle) is not a fantastic fit. It definitely looks like an amateur installed it. Also, the sliding cup holder will not close all the way anymore. But it looks nice and my cup holder is always out anyway.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

This made for a great look to the Dodge Grand Caravan. I had to do some additional trimming for the climate controls that was not mentioned in the installation guide.

Have questions for
?

Crutchfield response on

Great fitment

This was a life saver once I thoroughly read the instructions and understood them. I had issues when fiest trying to snap it in, that's when I notice a didn't perform the necessary sub daah modifications to allow the HVAC controls housing to fit in without obstruction (I had to cut away some tabs that were originally ment for the OEM lower tray). Once that was sorted out everything waa smooth sailing. Definitely not for someone who feels uncomfortable modifying their sub dash. Trims up the head unit well. There are larger gaps between the edges of the trim than with the OEM trim. I was expecting this though. Works great and because I bundled everything needed for the install I ended up saving lots of as opposed to buying everything in separate order to avert a large order. I am definitely pleased.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Fitment was great and the team at Crutchfield is awesome!! Thanks guys

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Perfect fit. Looks like it came in the car. As always Crutchfield has perfect instructions and great help along the way from when our installer made a mistake!

Have questions for
?

Crutchfield response on

Works but.....

So yes, this will fit the your Chrysler minivan. However the process won't be easy and unfortunately Crutchfield failed to support it by packaging up the correct instruction sheets in an easily locatable way. I followed the "custom install sheet for your vehicle" which was a joke frankly and didn't really address the realities of this job. Perhaps there are other sheets provided online which I simply never noted? At any rate yes there is sub-dash you have to saw out. As it turns out if you own the Town and Country like I do the the pocket at the bottom is screwed into the subdash and technically needs to be removed in order for this dash kit to work. Again, since I didn't have a good instruction sheet I didn't know that and wasted a lot of time in 90 degree heat trying to figure it out and not before I sawed out the pocket that is built into this. Thankfully you can modify the internal bay that technically has to be removed to actually fit with this dash panel. Its not perfect but it works. But I would recommend simply removing it when you do it which I should have done. On the '06 T&C the mounting bracket leaves a lot to be desired and currently it is still mounted too far back in my car leaving gaps between the dash panel and the radio. It is polymer so I could probably modify it if I can't find another workable solution but after 4 days in 90 degree heat working on this I'm "done" for now.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Does t fit great, but it works.

Have questions for
?

Crutchfield response on

Fits OK, finish may vary

Works OK, but only just. Better than cutting a hole in the stock panel. The finish isn't even and it looks non-original, with molding marks and waves. You can tell it's cheaper plastic. This is the only double DIN kit for the 01-07 Chrysler/Dodge minivans and I'm surprised they still make it. I used it for mounting a Sony XAV-AX7000. This radio has a single DIN chassis, at the top half and didn't require cutting the sub dash apart. I did have to notch the sub dash to the right of the AC control to get it to snap on. Put the metal clips on tight before mounting and they work fine. The radio wasn't centered properly so I embiggened the locator pin holes in the dash and shimmed the deck to center it. This takes patience.

Have questions for
?

Crutchfield response on

Front plate

Great fit and great look

Have questions for
?

Crutchfield response on

Could be better but it worked

The dash kit worked mostly OK. I had to use a rotary tool to remove the left and right edge of the stereo frame and after that it was a perfect fit. Also, I realized that the metallic clips from the original panel worked better so I used those. It was a bit hard to be able to clip it, I discovered that it was easier to first insert the right side, then push from the left to insert the left side. Finally, I wish the new panel had the same texture as the original, but other than that, it is a great option to install a double DIN stereo. My wife is happy with her new stereo installation and she says it looks very good.

Have questions for
?

Crutchfield response on

Dash Kit

Worked great!!! Installer was amazed

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

If it wasn't for the fact that this dash kit technically works, there is no way I'd recommend it. Forget about using the retaining clips that come with it. They don't work, and you'll find yourself prying the original retainers off of the original trim to install the new one. The bolt holes that hold the hazard switch panel in place are larger than the bolts are, so they don't hold either. You'll find yourself running either to the store or to your spare bolts and screws box to find something the correct size. The universality of the radio mounts will almost definitely mean trying different positions to try to center the radio properly. Aside from my qualms with the build quality of the dash kit itself, keep in mind that this is designed to fit a double din radio in a 1.5 din hole. I didn't realize it beforehand, but that requires taking a hacksaw to the plastic supports inside of your dash. I'm not saying that this kit doesn't work because I made it work. I will say that I wish I had just gotten a single din radio though. I feel that this wasn't worth it.

Have questions for
?

Crutchfield response on

Repeat customer

This is my 2nd pioneer 2400nex I purchased as a gift for the holidays. The first went smoothly the 2nd one the steering wheel controls would not recognize vehicle and the dash panel needed to be modified to fit. However I would purchase again in a heart beat Great radio and customer service. Thank you Eric.

Have questions for
?

Crutchfield response on

Great Part

Love how this part makes the transformation complete. Though installing based on instructions weren't very precise. Needed to remove a piece by cutting out and did that but there was two other tabs in the way that also needed cut out so the panel could be snapped in place. The new mount clips seem to fall off and hard to snap in.

Have questions for
?

Crutchfield response on

Doesn't fit properly

Switching the heating vents over as well as the heating controls was the easy part. Getting this to fit with the supplied metal tabs was ridiculous. I had to use the factory ones. The ones supplied with this kit were half the size of the factory ones and would not engage. Also, good luck trying to get the plastic cover on it for a finished look. It doesn't fit behind the panel. Or in front of it either. I am regretting going to a double din for my vehicle.

Have questions for
?

Crutchfield response on

Metra 95-6539 Dash Kit

Excellent product. Fits perfectly fine. Horrible finish black but you can customize paint.

Have questions for
?

Crutchfield response on