Metra 95-7369B Dash Kit

Fit perfectly on my car. And the matte black looks nice, moving the ac vents from the oem to this is a bit hard, but i managed. Crutchfield should include a small guide on how to remove it because the oem has a lot of plastic,and it can be a bit confusing which plastics or screws need to be removed.

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

The fit isn't perfect for my kenwood receiver but it did the job. Had to use some black tape to help hide the small gaps on the top and bottom of the receiver.

Have questions for
?

Crutchfield response on

Good enough

It does a lot right, it fits and is simple to figure out. The matte finish fits the rest of the vehicle. However, there isn't much adjustment for the new radio depth. This resulted in the radio pushing the dash kit out a bit, and there is a (not very noticeable) gap between it and the rest of the dashboard.

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Fits just right and looks great

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Perfect fit. Factory result

Have questions for
?

Crutchfield response on

frame

Grear fit looks great

Have questions for
?

Crutchfield response on

frame

easy to use and install

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Product meets need for double din install.

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

This is aaaaaaalmost perfect. Installation was easy, fit is great, look is great, but there are just a few little things: - As much as I love matte black on pretty much everything, this is 100% matte black and doesn't quite match the rest of the interior trim. It's close enough to be passable and still gives the installation a professional look, but it would be nice to see a couple options based on Hyundai's factory trims. - I installed a Pioneer DMH-W4660NEX with this, and the fit was almost perfect. One small gripe with installation: this piece comes with brackets to screw into the sides of your head unit, which is great, but there are approximately 300 screw holes on both the brackets and the head unit. Figuring out where I needed to screw the brackets in took several attempts. Additionally, I was left with about a 1/4 inch gap above the head unit. I fixed this by pushing a folded piece of black craft foam in from behind, and I think it looks pretty good all things considered (see photo). - The actual fit into where the piece goes is perfect, but no matter how hard I push, it's still not sitting 100% flush at the bottom. It's not so bad it's noticeable, but I know it's there and it's driving me a little bit crazy. It seems like the clips on this piece aren't quite as secure as the clips from the factory piece. All in all, definitely an essential buy when replacing your factory radio. Just be aware of the above!

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Makes for a seamless install that looks factory.

Have questions for
?

Crutchfield response on

Not a great fit for Alpine iLX-W650

Nice matte black finish, didn't match my current silver trim but looks good just the same. Well built and sturdy, not difficult to put in. The cut-out opening was too big for the Alpine ILX-W650 I also purchase at Crutchfield. 1/8 of an inch all the way around. I had to make black curtains/trim to place behind the plastic opening so I wasn't looking through and seeing vents, wire, frame, etc.

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Very nice material. Loved the product.

Have questions for
?

Crutchfield response on

Metra 95-7369B Dash Kit

Nice kit not good match to factory dash trim car has silver trim

Have questions for
?

Crutchfield response on