Its garbage
Brian from Nampa, ID on 7/20/2024
Its trash. Ive installed 20 or 30 stereos in my life and this was by far the worst experience ive ever had. I wish i could go back and decide to leave the OEM stereo in place. First the brackets- My double din stereo has a double screen but single din body, so only one of the 3 side bracket screws could attach. I went to home depot and got some flat steel, bent it 90, glued it to the stereo, and then was able to use all 3 screws. The brackets are plastic, so tightening the screws tried to push the bracket apart. I had to bend some metal washers into the screw holes to make it sturdy. The face plate is cheap, thin, flimsy plastic. The bottom does not pop into place like the oem part. The middle does pop in. The top does not pop in, and so it sticks out over the horizontal dash trim. I removed the dash trim, pushed the face under, and put the trim back on top, and the face worked its way back out immediately. The instructions did a decent job of explaining how to cut the dash, but there was still some trial and error required.
Pros: lol, no.
Cons: poor quality, poor fit
2 of 2 found this helpful
At a complete loss
Anthony from Kansas on 12/26/2023
2010 BMW 1 Series
Does not fit at all. Heater controls clip in and inch deeper than this kit allows. Large gap on drivers side 2010 bmw 128i base coupe
Pros:
Cons: DOES NOT FIT, already cut pieces off the car as the instructions stated and in the end it doesn't fit and I've ruined the inside of the console
2 of 2 found this helpful