Metra 99-7308 Dash Kit

great item

Have questions for
?

Metra 99-7308 Dash Kit

Could not use wrong installation kit!!!!

Have questions for
?

Metra 99-7308 Dash Kit

Perhaps it wasn't the fault of this kit, but once installed I could not get the large trim of the car completely back into place because the stereo projected too far out of the dash. I first tried shaving the dashboard trim (not this piece), but realized it would take a lot of shaving. I ended up rotating this piece which resulted in the stereo sitting a little deeper in the dash. The trim could now fit, but the stereo is a tiny bit loose. Still secure.

Have questions for
?

Did the job

Did the job but directions could have been better. Didn't take long to figure out.

Have questions for
?

Best customer service!

Crutchfield is handsdodwn the best company i have dealt with period They have turned this old dog into a halfway decent installer with there amazing customer service!

Have questions for
?

Metra 99-7308 Dash Kit

No good for my car but probably nothing wrong with it.

Have questions for
?

Metra 99-7308 Dash Kit

Fit just right.

Have questions for
?

Dash mount kit

Helped make installation easy.

Have questions for
?

Metra 99-7308 Dash Kit

Works exactly as intended

Have questions for
?

Metra 99-7308 Dash Kit

Fits just as it should and holds everything in place.

Have questions for
?

Metra 99-7308 Dash Kit

Did what it was designed to do. Easy to install.

Have questions for
?

Does what it's supposed too

Fits well and can be rotated 180° to adjust height differences in dash opening

Have questions for
?

Unnecessary

The product itself fit well on the din sleeve for the purchased car stereo, but I didn't need to use it for my install in a 2003 Hyundai Elantra. Rather than using this product to fit my car stereo, I used the original mounting brackets since without it, I would be missing a pocket area.

Have questions for
?

Perfect fit

I ordered this but didn't need it afterall. It would of been a perfect fit if I would of used it, the only problem would of been that it didn't have the pocket underneath it witch my car already had from a previous install.

Have questions for
?

Fit Perfectly

Fast shipping & the bracket fit perfectly; Crutchfield always offers great guidance prior to purchase; when I ordered I was confident that I would have everything I needed for an easy install and Crutchfield came through for me again

Have questions for
?

It's ok 99 Hyundai Accent

The kit fit good and it came with spacers but the screws used on the old receiver were too short to use when you tried to use the spacers. I currently have a gap under my radio until I can find longer screws to place the spacers in.

Have questions for
?

Metro dash kit

Had no issues installing this in my 05 Hyundai Accent worked great

Have questions for
?

Metra 99-7308 Dash Kit

Works as advertised

Have questions for
?

Metra 99-7308 Dash Kit

tried to install it in an 04 Hyundai elantra absolutely none of the parts would work for an in dash install only way to use it would be to cut portions of the dash surround. I had to make my own housing to install properly with little effort on my part

Have questions for
?

Great product

Fit radio nice.

Have questions for
?

Great Product

It was easy to install and it was very easy to adjust it to fit my dash.

Have questions for
?

good fit

great fit easy to use

Have questions for
?

Worked as stated

As always from Crutchfield the in dash kit worked flawlessly.

Have questions for
?

Was not needed 02 Elantra

the product was what it says it is, so i can't say its junk but was not needed for my vehicle, not sure why it was included

Have questions for
?

metra 99-7308

Well worth the money. Made installation much easier.

Have questions for
?

Receiver kit

Good product. Fit well and was sturdy too.

Have questions for
?

Metra 99-7308 Dash Kit

Made installation "easy as pie". Thanks Crutchfield.

Have questions for
?

Elantra dash kit for sterio

This mounting bracket was unneeded and worthless. This is set-up for a radio with a knob on each side, like it was in the sixties. Left one volume, right one channels. And the 2006 Elantra doesn't need a special mounting kit, I found out.

Have questions for
?

Looks great. Doesn't fit.

Looks fabulous however even after double checking that I ordered the right for the right car, the item does not fit my dash.

Have questions for
?

03 elantra gls. Didn't fit to my liking

Car is a 2003 hyundai elantra gls. Installed this to the radio and didn't like the way it fit. After several adjustments, I still wasn't happy with fitment. Went to a different electronics retail store and picked up a different dash kit with tray underneath. Worked and fit a whole lot better.

Have questions for
?

Hyundai GT 2004 In-dash Receiver Kit

I really didn't need this kit, except for a couple of screws, but it's nice to have in case I want to use this for another vehicle.

Have questions for
?

Did the job.

Not much to say, it worked well. Nothing exciting here.

Have questions for
?

Very good but needed to be used backwards

Ended up only fitting when I placed it opposite of instructions but overall was a great fit and my stereo sits quite well.

Have questions for
?

in dash receiver kit for Elantra 2002

Fit perfectly, just follow the instructions

Have questions for
?

Does not fit 2004 Accent

The kit does not fit 2004 Hyundai Accent GLS DIN. I used a mounting frame purchased from another source. However, the JVC unit still left a visible gap around it.

Have questions for
?

Metra 99-7308 Dash Kit

worked great. easy install.

Have questions for
?

Not too difficult of an install

Documentation OK, but had to make some judgements along the way due to a few vague areas in documentation.

Have questions for
?

Hyundai In-dash Receiver Kit

The Hyundai In-dash Receiver Kit (2006 Elantra)does not fit. First, you are instructed to remove the support bracket behind the radio - which is near impossible unless you use a saw.(not a good idea) Second, you are instructed to connect (screw) the radio bracket to the pocket below. Unfortunately this is not explained well and the screw holes do not line up. If you do manage all of this the bracket still doesn't fit. At least not in my vehicle. Fortunately a friend supplied me with a bracket that was one piece(both the bracket around the radio and the pocket below it) This is the bracket that should be supplied. How much more could it cost. It fits perfectly without removing the support bracket or connecting the pocket to the new radio.

Have questions for
?

Metra 99-7308 Dash Kit

Pretty straight forward installation.

Have questions for
?

Metra 99-7308 Dash Kit

This unit fit great. I at first tried to use the spacers included in the package, but that prevented the trim of my 2006 Hyundai Elantra from being reassembled correctly. It would have been nice to see the instructions note that the spacers weren't needed on my car. Also, as a side note, the trim of the Elantra prevents the trim that came with my stereo from being applied. This has nothing to do with this particular product, but is just something to be aware of when purchasing a stereo for this car model. The stereo still looks fine sitting in the Hyundai trim.

Have questions for
?

Metra 99-7308 Dash Kit

Installed on a 2003 Hyundai Accent and a Kenwood stereo. Instructions were clear and easy to install. Fit like a charm.

Have questions for
?

Metra 99-7308 Dash Kit

Fit into my car perfectly

Have questions for
?

Fit perfect!

This fit the radio and slot in the car perfectly. (06 Hyundai)

Have questions for
?

Not sure what the small pieces did

Without the little extra pieces which weren't explained in the kit instructions, the holes were bigger than the heads of the screws that held the original in. Those spacers or whatever they were would have solved the problem if they could be mounted on the front, but I couldn't get them to attach except behind the main bracket, and the way they were marked (L and R) and the way the holes lined up, that was how it was intended. But put behind, they were pretty much useless unless I glued them in. I ended up having to get some washers to make the heads of the screws wide enough. As other reviewers noted, try the original mounting brackets with your new radio first, it might make it go much smoother.

Have questions for
?

Does what it claims to do

This product worked as intended. It did not break during installation, though you have to be careful when cutting out the squares, as other reviewers have indicated.

Have questions for
?

Metra 99-7308 Dash Kit

This kit did not work in my 1999 Elantra. The weight of the stereo caused the plastic to bend slightly, and the dash would not line up correctly because of it. Fortunately for me, the after-market stereo which I was removing had metal brackets that were strong enough to hold the stereo in place. Obviously, it has worked for some people. I suppose this is a warning to Elantra owners: do yourself a favor and try to find a metal install kit.

Have questions for
?

Metra 99-7308 Dash Kit

I dropped down to 4 stars because of the need to cut off the front mounting knob holes area out of the mounting plate. Other than that it does what it is suppose to & it fits.

Have questions for
?

Fits well, breaks easily

Fits perfectly. For the receiver I bought, I needed to remove the two knob supports (the big black rectangular sections with large holes on each side), which was described well in the instructions. You must be careful, however. Once you cut through a few of the joints that hold the knob supports, the frame becomes substantially weaker. Mine broke, but I was still able to use it as it serves more of a "filler" purpose than a mounting one. It makes the radio look like it fits perfectly in the console, but breaking one of the corners didn't substantially affect fit, appearance or function. Still, I wish it hadn't broken; it was the only thing that went wrong during installation.

Have questions for
?

Metra 99-7308 Dash Kit

Seems sturdy and very functionaly but I didn't need it to install a sony xplod receiver in my 2002 hyundai accent GL.

Have questions for
?

Didn't Need for my Sony X-Plod Stereo

I have a 2005 Hyundai Elantra with the single CD player (single wide with storage compartment below it). I was able to install the player easier with the mounting bracket from the old stereo (The L Shaped bracket that also holds the storage compartment) with screws provided in the new Sony stereo. On another note. The mounting bracket I received for my old Galant was made of metal and very solid. This new bracket was made of plastic and seemed very cheap. Seems like it could break very easily.

Have questions for
?

Metra 99-7308 Dash Kit

Had to do quite a lot of trimming to get it to fit in the console of the 2005 Hyundia Accent.

Have questions for
?

Very easy to install

I used this kit to install JVC Arsenal KD-AHD39 receiver into my 2004 Hyundai Elantra. At first I took it to my dealership to have them install it, since I'd never installed a radio before. Apparently the mechanic there had no idea what he was doing, because after two hours he told me that this was the wrong kit and that it wouldn't work. I took the unit home and tried to install it myself. 45 minutes later it was in my car and working well. I guess I learned my lesson about having the dealer install a stereo. I found the instructions to be very clear for someone who has never installed a receiver before.

Have questions for
?

Metra 99-7308 Dash Kit

Fit was fine installing a Jensen HD5212 in my wife's 2003 Hyundai Elantra. It did take me a while to determine that the black trim plate on the Jensen Stereo needed to be removed before this smaller trim piece could be used properly. (The stock trim plate from Jensen was too wide to fit in the Elantra DIN opening.)

Have questions for
?

Hyundai Kit

The kit worked well to install the radio. The only issue I had was to figure out which of the 2 installations to use (DIN or std.).

Have questions for
?

Metra 99-7308 Dash Kit

The kit worked perfectly for installing the radio in my car. Only problem i had was the factory radio wasn't screwed in so i had no screws to screw the new radio in with! I ended up using some extra license plate screws to secure this kit cause they were the same size. May depend on your car whether you have screws in your radio or not but be prepared to go get some if you don't have any of the same size. The size seemed to not matter so much though cause it just screwed into some foam behind the dash.

Have questions for
?