Crutchfield custom wiring harnesses help make installing an aftermarket receiver in your car a little easier by saving steps. Simply splice the color-coded wires on your Crutchfield harness to the wires from your aftermarket radio. Most of the wire splices can be made on your work bench or kitchen table; soldering is best, crimping is also very popular.

Next, simply plug the Crutchfield harness into the harness that you removed from your factory radio.

Since you didn't have to cut off your car's original radio connector, it's easier to put the factory radio back in when you sell your vehicle or return it at the end of the lease. Just plug the factory radio back in and keep the aftermarket radio. Best of all, the harness is free with most of the receivers Crutchfield offers. 30-day warranty.

Connections:

Note: New speaker wires may need to be run to speakers when installing a new receiver with this harness. In addition, you'll need to make a ground connection between your new receiver and your car's chassis.

• 12V constant power
• 12V switched power
• dimmer