Crutchfield custom wiring harnesses help make installing an aftermarket receiver in your car a little easier by saving some steps. Simply splice the color-coded wires on your Crutchfield harness to the wires from your aftermarket radio. Most of the wire splices can be made on your work bench or kitchen table; soldering is best, crimping is also very popular.

Next, simply plug the Crutchfield harness into the harness that you removed from your factory radio.

Since you didn't have to cut off your car's original radio connector, it's easier to put the factory radio back in when you sell your vehicle. Just plug the factory radio back in and keep the aftermarket radio. Best of all, the harness is free with most of the receivers Crutchfield offers. 30-day warranty.

Connections:

Note: The 12V constant power lead may not be present in some 1982-84 Toyota models. If not present, and your receiver requires a constant 12V memory lead (most do), run a wire directly to the battery or an appropriate un-switched fuse. This harness does not include any speaker connections. New speaker wires may need to be run from your receiver to the speakers when installing a new receiver with this harness.

• 12V switched power
• chassis ground
• dimmer