About the Crutchfield Banana Connectors
We like banana connectors — especially for the space-challenged rear panels of A/V receivers. These connectors use a set-screw design that provides reliably easy and secure speaker wire termination. If your receiver, amplifier, or speakers have banana-compatible binding posts, these connectors are a low-cost way to plug in.
Product highlights:
- provides an easy and secure connection between your 16- or 14-gauge speaker wire and your banana-compatible speakers, receiver, or amplifier
- a set-screw secures your speaker wire to the banana connector (screwdriver included)
- 24k gold-plated contacts resist corrosion
- red and black Crutchfield logos to identify positive and negative
- warranty: 1 year
- Our 60-day money-back guarantee
- MFR # B20PK
What's in the box:
- 20 Banana plugs
- Flat-blade screwdriver
Reviews
Customer reviews
Loading reviews...
Crutchfield Banana Connectors reviews
Average review:
Customer photos
This review was collected as part of a promotion
Pros:
Cons:
More details on the Crutchfield Banana Connectors
Product Research
Features
Crutchfield Banana Plugs: The Crutchfield banana plug connectors provide an easy and secure connection between your 16 or 14 gauge speaker wire and your loudspeakers, receiver, or amplifier. Set-screws secure your speaker wire to the banana plug connector (strip your speaker wire 0.5"). Each Crutchfield banana plug connector features a gold-plated single-banana jack which easily plugs into the binding post terminals of your loudspeakers, receiver, or amplifier. The barrel of each connector has a red or black "Crutchfield" logo to identify positive and negative.
- Connector Diameter: 0.215"
- Barrel Diameter: 0.425"
- Overall Length: 1.805"
Note: Available in a 2, 10, or 20 pack.
Installation Instructions: Twist the banana plug connector clockwise to loosen the connector from the barrel. Slide the connector down through the barrel until it comes out and then loosen the set-screws. Strip your 16 or 14 gauge speaker back 0.5" and insert it up through the hollow end of the banana connector. Tighten the set-screws onto the inserted speaker wire and slide the banana connector back through barrel. Twist the banana connector counter-clockwise to tighten the assembly and plug the banana connector into the binding-post terminal of your speakers, receiver, or amplifier.
Loading accessories...
Customer Q&A
3 questions already asked
Loading articles...
Attaching bare speaker wire to receiver posts for a 7.1.4 setup = no good! These were the perfect solution to simplify connectivity. While not hard to figure out, it would be nice to have some sort of simple instruction included in the pack.
Robert from Collegeville, PA