T-Spec v12 Series VPNB2 Mini ANL fused distribution block for power and ground cables — two 1/0-gauge inputs, each to two 4- to 8-gauge outputs (fuses not included)

Features

Overview: The T-Spec VPNB2 compact power & ground distribution block is constructed of solid black nickel-plated brass for maximum conductivity. The distribution block features a translucent, impact-resistant polycarbonate cover with TPE (Thermoplastic Elastomer) grips for easy cover removal. The distribution block has a small footprint, with two holes in the base for mounting using screws or wire ties (both sold separately).

Configuration: The VPNB2 distribution block features 2 power input ports into a single input block with each port accommodating a 1/0 AWG wire (only one input port needs to be connected). Two power outputs can accommodate either 4 or 8 AWG wire and get connected to the input block via mini-ANL fuses (sold separately). Rubber grommets and sleeves are provided on the inputs as well as the outputs. The output grommets can be removed, with only the rubber sleeve installed, allowing 4 ga. wire to be inserted. These provide a tight seal against dirt or particle ingress with either size wire. The center section of the distribution block features a single ground block with one 1/0 AWG input and two 4 AWG outputs.

Set Screws: Input, output, and fuse connections are secured with Torx T-20 set screws. A T-20 Torx driver (sold separately) is required to tighten or loosen the set screws.

Optional Ferrules: Install Bay (Metra) wire ferrules (sold separately) are designed to crimp onto your power, ground, or speaker wire and provide a clean, solid connection to your terminal block or amplifier with set-screw connections. Bare wire is slid into the length of the ferrule and then crimped onto the wire. This keeps all copper strands held tightly together, with no splaying while tightening the terminal connection. Install Bay wire ferrules can be found here.